en-43
7 OPERATION
7.4 SETTING UP THE MACHINE ____________________________________________
Check the hydraulic system. Make sure the connections are tight and all hoses and lines are in good condition
before pressurizing the system. Hydraulic system should be allowed to warm-up and re-check connections for
leaks.
NOTE: Any reference to the right, left, front, or rear of the unit will always be determined from the operators
seated position.
WARNING
Setup procedures must be performed as
specified by properly trained service
personnel only.
WARNING
If a leak is suspected, use a piece of
cardboard or wood, NOT your hand, to
check for leaks.
Hydraulic Fluid escaping under pressure
can penetrate skin and do serious
damage. Immediate medical assistance
must be sought.
Serious infection or reaction can develop
if proper medical treatment is not
administered immediately.
To Next Page
Loading...
Need help?
General
