Thales ADS-B - Fig.−No. Title Page

AS 680/682
Table of Contents Description, Operation and Maintenance
ADS−B
XVI Ed. 10.07
Fig.−No. Title Page
Fig. 2−29 LCMS subsystem tools 2−24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 2−30 Detailed BITE Status display on RCMS (example) 2−26. . . . . . . . . . . . . . . . . . . . . .
Fig. 2−31 ADS−B Technical Situation Display (example) 2−26. . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 2−32 Display Configuration tool for the Technical Situation Display (example) 2−27. . .
Fig. 3−1 24028 28001, Status cable Site Monitor, SubD/9pin to SubD/15pin 3−3. . . . . .
(used with AS 680)
Fig. 3−2 240xx 28xxx, Status cable Site Monitor/Intrusion, SubD/9pin to SubD/15pin 3−3
(AS 682)
Fig. 3−3 27288 04059, ANT AAU cable, RF, N−N 3−3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 3−4 27288 04140 to 42, Ground Station internal RF−cable to Exchange Panel, 3−3
RF, N−SMA . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 3−5 24028 28002, BITE connection cable, RJ45, 8/8 to RJ45, 8/8, crossed 3−4. . . .
Fig. 3−6 24028 28003, LCMS serial cable, SubD/9pin to MicroSubD/9pin, crossed 3−4.
Fig. 3−7 24028 28004, LCMS Ethernet cable (standard), 10/100Base−T, RJ45, 8/8, 3−4.
cross over
Fig. 3−8 24028 xxxxx, LCMS Serial to USB adapter cable, SubD/9pin to USB A, 3−4. . . .
optional
Fig. 3−9 System cabling ADS−B Ground Station AS 680 (one station shown) 3−5. . . . . .
Fig. 3−10 ADS−B Ground Station AS 680, SPU, power connection rear side 3−6. . . . . . . .
Fig. 3−11 RCMS, system cabling 3−6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 3−12 System cabling ADS−B Ground Station AS 682 (1) 3−7. . . . . . . . . . . . . . . . . . . . .
Fig. 3−13 AS 682, SPU power connection rear side 3−8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 3−14 System cabling ADS−B Ground Station AS 682, Data Switch and UPS (2) 3−8.
Fig. 3−15 Cabling and arrangement example of Exchange Panel 3−11. . . . . . . . . . . . . . . . . .
Fig. 3−16 Test setup frequency check of local oscillator of RXU 3−16. . . . . . . . . . . . . . . . . . .
Fig. 3−17 Test setup sensitivity level adjustment of RXU 3−17. . . . . . . . . . . . . . . . . . . . . . . . . .
Fig. 3−18 Receiver sensitivity level setting, signal at monitor output (1 of 3) 3−17. . . . . . . . .
Fig. 3−19 Receiver sensitivity level setting, signal at monitor output (2 of 3) 3−18. . . . . . . . .
Fig. 3−20 Receiver sensitivity level setting, signal at monitor output (3 of 3) 3−18. . . . . . . . .
Fig. 3−21 RCMS desktop panel to start up the MTSC and the TSC application 3−21. . . . . .
(example)
Fig. 4−1 RCMS desktop panel with the set of application software (example) 4−1. . . . . .
Fig. 4−2 LCMS desktop panel with the set of application software (example) 4−1. . . . . . .
Fig. 4−3 Structure of the application software on the LCMS and the RCMS 4−2. . . . . . . .
Fig. 4−4 RCMS Configuration with the two screens used for the MTSC application 4−5.
Fig. 4−5 Structure of the MTSC Main Window on screen 1 (example) 4−6. . . . . . . . . . . . .