13
Chapter 2: Hardware Installation
Overview
Your N5200PRO is designed for easy installation. To help you get started, the
following chapter will help you quickly get your N5200PRO up and running. Please
read it carefully to prevent damaging your unit during installation.
Before You Begin
Before you begin, be sure to take the following precautions:
1. Read and understand the Safety Warnings outlined in the beginning of
the manual.
2. If possible, wear an anti-static wrist strap during installation to prevent
static discharge from damaging the sensitive electronic components on the
N5200PRO.
3. Be careful not to use magnetized screwdrivers around the N5200PRO’s
electronic components.
Hard Disk Installation
The N5200PRO supports four standard 3.5” Serial ATA (SATA) hard disks. To
install a hard disk into the N5200PRO, follow the steps below:
1. Remove a hard disk tray from the N5200PRO.
2. Slide the new SATA hard disk into the tray and fasten the screws.
3. Insert the hard disk and tray back into the N5200PRO until it snaps into
place and lock it with a key if desired.
4. The LED blinks green when the hard disk is accessed. If the Error LED
flashes red it signals a problem.
NOTE
If your HDD was part of a RAID 1 or 5 array previously, it automatically rebuilds. If
you replace all the drives with higher capacity drives, you need to go to
Administrator login and format the drives.
To Next Page
Loading...
Need help?
General
