Thermal Dynamics CutMaster 40MM User Manual

CUTMASTER 40MM
Manual 0-5084 SERVICE
5-1
SECTION 5 SYSTEM:
SERVICE
5.01 General Maintenance
Warning!
Disconnect input power before maintaining.
Each Use
Visual check of
torch tip and electrode
Weekly
Visually inspect the torch body tip,
electrode, start cartridge and shield cup
Visually inspect the
cables and leads.
Replace as needed
3 Months
Clean
exterior
of power supply
6 Months
Replace all
broken parts
Visually check and
Carefully clean the
interior
Maintain more often
if used under severe
conditions
Art # A-07938_AB

Thermal Dynamics CutMaster 40MM Specifications

General

Brand	Thermal Dynamics
Model	CutMaster 40MM
Category	Welding System
Language	English