10 GENERAL INFORMATION
SERIAL RATING PLATES
Serial Number Rating Plates on each vertical cabinet are located on the inside upper left hand corner.This plate
contains all technical data necessary to the operation of the cabinet. (Sample below.) Warranty administration is
based on the serial number as printed on the rating plate.
GROUNDING INSTRUCTIONS
This appliance is equipped with a three-prong
(grounding) plug for your protection against shock
hazards.The appliance should be plugged directly into
a properly grounded three-prong receptacle.
Where a two-prong wall receptacle is encountered, it
must be replaced with a properly grounded three
prong receptacle in accordance with the National
Electrical Code and local codes and ordinances. The
work must be done by a licensed electrician.
IMPORTANT
Do not under any circumstances cut or remove the
round grounding prong from the equipment plug.
WARNING
Consult a licensed electrician if you have any
doubt about the grounding of your wall recepta-
cle.Only a licensed electrician can determine the
polarization of your wall receptacle. Only a prop-
erly installed three-pronged wall receptacle
assures the proper polarization with the equip-
ment plug.
MODEL SER.
REFRIGERANT VOLTS
TYPE # WIRES PHASE HERTZ
CHARGE TOTAL AMPS
MAXIMUM
DESIGN MINIMUM FUSE SIZE
PRESSURE (PSIG) REFRIG. DEFROST LOCKED CIRCUIT OR HACR TYPE
HIGHSIDE
CYCLE CYCLE ROTOR AMPACITY CIRCUIT
LOWSIDE
BREAKER
FLAMMABLE MATERIAL STORAGE
To meet the requirements for storing flammable material, cabinet has no opening other than
the door, or any electrical components below compressor compartment.
DO NOT MODIFY CABINET OR REMOVE LABEL ON THE FRONT WHICH SPECIFIES STORAGE LIMITS!!
To Next Page
Loading...