DOOR GASKET REPLACEMENT
Thermo Forma gasketing is replaceable on glass or
solid door models. A retainer is molded into the door
frame.The door gasket is then tapped into the retain-
er and secured for airtight door seal.
1. Remove door from cabinet.
2. Lay door front down on a flat, firm, nonscratch sur-
face.
3. Pry up one corner of gasket with a putty knife or
screwdriver. Pull gasket from perimeter of door
retainer. Clean new gasket and straighten to
insure proper fit.
4. Pull gasket from perimeter of door retainer.
5. Clean new gasket and straighten to insure prop-
er fit.
6. Place gasket over retainer in door frame.
7. Using a rubber mallet, tap the gasket into the
retainer. (NOTE: Gasket can be soaked in warm
water to make pliable.)
8. Place door back onto cabinet.
MAINTENANCE & REPAIR 47
To Next Page
Loading...