TOUCH-UP PAINTING INSTRUCTIONS - Spray Paint
1. Sand to bare metal on affected area and its edges
until the edges are smooth or feathered. This
insures that you are spraying on to a clean area that
has adhesion.
2. Use an automotive primer (lacquer) over the bare
metal.
3. Scuff sand the primered area lightly.
4. Test spray can before using on cabinet surface.Apply
in short, even strokes holding can 10" to 12" from sur-
face, and moving rapidly during use. Apply paint in
thin layers (4-5 layers minimum) with air drying time
in between coats. Scuff sand very lightly between
coats. This will remove uneven spots or roughness
and will create a high gloss, smooth finish.
5. Use rubbing compound (preferred) or wax over the
finished area after a few days of hardening/drying
time.
54 MAINTENANCE & REPAIR
To Next Page
Loading...