P10
MAIN MENU
Use pq to select Scan mode, and select between Free which will only install Free-to-Air channels or All.
This means that channels that are Free-to-Air or scrambled will be searched and stored.
Use pq to select Channel No and select the channel number of the frequency you’d like to search. Press
OK to open a list to make selection faster.
The next option Modulation is to select between Only DVB-T or DVB-T+T2 modulation type.
When in doubt, use the DVB-T+T2 setting.
If you use an active antenna (with built-in amplifier), then switch the Antenna Power to On. If you use a
passive antenna (without built-in amplifier), then select Off.
Highlight Search and press OK to start scanning. New found channels will be added to the channel list.
7.1.2 Auto Search
This menu allows you to search for channels from all available Frequencies or Channel numbers. Be aware
that all previous installed channels and favourite list(s) will be deleted. The new found channels will be
installed in the channel list and afterwards you can create a new favourite list if you like.
Select Scan mode, and select between Free which will only install Free-to-Air channels or All. Highlight
Search and press OK to start scanning.
7.1.3 Information
This submenu shows receiver specific information such as hardware and software version. It also displays
technical information from the currently selected channel and signal strength and quality. Please have the
Information screen on hand when you call our hotline. The person who answers your call might ask for the
information given in this screen.
7.1.4 Load Factory Settings
This option allows you to reset the receiver back to the factory settings, which also clears all stored
channels.
Use pq to select Load Factory Settings in the Installation menu and press OK. You are asked to enter
your PIN code. Enter the correct PIN code using the 0~9 buttons. (DEFAULT PIN: 0000). A confirmation
window is displayed. Select OK to load factory settings. Select Cancel to cancel. Press to leave.
WARNING: By resetting your receiver to factory default, all your settings and stored channels will be
permanently deleted. Please use this option with care.
7.1.5 Freenet Menu
Conditional Access (CA) menu. Read technical data about your subscription(s). Read a message from your
provider and check the rights to watch certain programmes. A Software update is signalled here too.
Follow the instructions on screen. Some data given has no immediate meaning to a client, but is useful to
for example a service centre or provider itself. This menu gives access to the following submenus which
can be opened for detailed information about these items: Service Status, Loader Status, Product Status,
Client Status and Mailbox.
7.1.5.1 Mailbox
This menu allows access to provider mails. It is used for sending important information from broadcaster/
content provider to you. If you receive a mail you will get this message directly displayed on screen. After
the mail has been removed from the screen you can find the messages within the menu and have the
possibility to delete messages individually by pressing the BLUE Delete button or to delete all of them by
pressing the RED Delete ALL button.
7.2 Channels
Use tu to select Channels in the main menu.
Use pq to highlight the submenu of choice and press OK to select.
To Next Page
Loading...
