THOMSON THT740 - 2.0 RECEIVER HARDWARE OVERVIEW

P4
YOUR RECEIVER
Warning: Indicates warning information.
Tips Indicates any other additional important or helpful information.
MENU Represents a button on the remote control or the receiver.
(Bold characters)
Move to Represents a menu item within a window.
(Italic characters)
1.4 Accessories
• Installation instructions
• 1remote control unit
• 2x batteries (AAA type)
• Power adapter12V DC, 1.5 A
WARNING: The batteries should not be recharged, disassembled, electrically short-circuited, be mixed or
used with other types of batteries. If rechargeable accumulators instead of batteries are going
to be used (e.g. NiMH), we recommend using types with low self-discharge to ensure long time
operation of your remote control.
1.5 Usage of external USB devices
• The USB port supports multimedia player functions and can be used to update your receiver software.
Recording function via USB is NOT supported by this receiver.
• STRONG cannot guarantee the playback of all multimedia files although extensions are listed, as it depends
on file size, codec, bit rate and resolution.
• It is advised not to store important information on USB storage devices used with the receiver.
• Playback of files cannot be guaranteed although extensions are listed, as it depends on codec, data bit rate
and resolution used (all MPEG codec formats are supported).
• Always make backups of data on your USB storage device before using it with this receiver.
• STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 0000
2.2 Front Panel
Fig. 1
1. q Switches the receiver ON or into Standby
2. P- /P+ buttons Switches to the previous/next programme
3. IR Sensor Receives commands from the remote control
4. LED Display Shows channel number and the time in standby
5. Mode Indicator LED
RED indicates that the receiver is in STANDBY mode. GREEN indicates that the
receiver is in operation mode.
6. Card slot For service purposes only. No user function.
2.3 Rear Panel
Fig. 2
1. ANT IN To connect to your antenna (room, -outdoor or roof antenna) for reception of
broadcast signals.
2. ETHERNET To connect to your Ethernet cable (RJ-45) for RSS feeds and weather forecasts
3. AUDIO L/R To connect your receiver to an analogue audio amplifier.