THOMSON THT740 - 2.4 Remote Control Functions

YOUR RECEIVER
P5
English
4. USB To connect your USB storage device.
5. HDMI To connect your receiver with your TV-set using an HDMI cable.
6. S/PDIF Coaxial To connect your receiver to a digital home cinema set, AV receiver or digital audio
amplifier.
7. TV SCART To connect your receiver with your TV-set using a SCART cable.
8. DC POWER To connect to the original included main power adapter (100-240V AC ~ 50/60
Hz/12 V, 1.5 A DC )
2.4 Remote control
Fig. 3
1. q Switches the receiver On/Standby.
2. ! Mutes all audio outputs of the receiver
3. FAV Opens the favourite group selection.
4. LIST Call the current channel list.
5. AUDIO Opens the audio* language selection
6. 9 One step back in menu or back to previous channel.
7. COLOUR BUTTONS
In different menus for specific functions
8. Opens the current channel information; 2x opens the current event information
and 3x the next event information.*
9. EPG Opens the EPG* (Electronic Programme Guide) in TV mode.
10. pq Change channel to next/previous.
Menu: Moves the cursor up/down.
11. t u Decreases/increases the volume level.
Menu: Change settings for specific menus.
12. OK Opens the current channel list in menu: for confirmation
13. MENU Opens the main menu, in a menu you will get one step back.
14.  Exits from the menu or sub-menu.
15. VOL+/VOL- Increases/decreases the volume level.
16. P+/P- Page up/down in all list modes.
17. CH+/CH- Channel up/down.
18. 0~9 Enter channel number in TV mode or value input in menu
19. TV/R Toggles between TV or RADIO mode.
20.  No function
21. 2 To pause the playback of multimedia files
22. 5 6 Fast rewind/fast forward.
23. 4 No function**
24. u Opens the multimedia menu
25. 7 8 Jump function in multimedia playback
26. 3 Stop playback.
27. OPT Opens quick menu to adjust screen settings
28. TEXT Opens the Teletext* if available
29. SUB Shows a list of subtitle* languages.
30.  To read messages from your provider.
*Subtitles, Videotext, EPG (Electronic Programme Guide), and Audio languages are depending on availability in the specific broadcast
**The recording function is not supported by this receiver.
2.5 Installing the batteries
Fig. 4
Open the cover on the remote control and insert 2x AAA type batteries into the compartment. Observe
correct polarity of the batteries when inserting. A terminal diagram is shown inside the compartment.