THOMSON THT82 - Starting Up for the First Time

English
7
indications for a low device speed. Thomson cannot guarantee proper functioning of recording and
or Timeshift functions with all USB devices.
4.0 STARTING UP FOR THE FIRST TIME
If you use your receiver for the rst time, the Installation Guide menu appears. Use pq to move the
highlight to the setting you wish to change and use t u to change values. Start by selecting your
On-Screen Language (OSD) using t u. Once you have selected your language, press q to move
the highlight to Country. Select your country using t u.
Other options are:
Antenna Power: Set to On if you use an active antenna. When set to On, a 5 Volt power will
be present on the RF IN connector of the receiver. Select O for passive
antennas.
Scan mode: Select All to store scrambled and free to air channels or select FTA to store
only Free-To-Air channels. Note: Scrambled channels you cannot watch with
this receiver.
Once all settings are made, move the highlight to Channel Search and press OK to start scanning.
The receiver will now search for all available channels. Once scanning is nished, the receiver switches
to viewing mode.
NOTE: Selecting the wrong country may result in a disorderly channel list, and
missing of channels.
TIP: In case the Installation Guide menu does not appear after switching on
the receiver the rst time, reset the receiver to factory settings by pressing
the MENU button and selecting Restore Factory Default in submenu
System. (Default PIN 1234)
5.0 QUICK GUIDE TO USING YOUR RECEIVER
We at Thomson understand that you can't wait to enjoy your new high denition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the q button on the remote control.
Choose the desired channel with the pq buttons. Alternatively, you can digit the channel number
with the 0~9 buttons on the remote control. Or press OK in viewing mode to display the channel list.
The volume can be adjusted with the t u buttons.
Default Password is 1234.
6.0 OPERATION
Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter 7.0 to get familiar with the menu of your
receiver.
6.1 Changing channels
Your new receiver is equipped with four ways to change channels.
Via direct access using the 0~9 buttons.
Via the channel list trough OK button.
Via the PG+ and PG- keys in (long) channel list.
Via the pq keys.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 keys on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
is possible. Just wait a few seconds and your receiver will switch to the selected channel or press OK
immediately after selecting the channel number.