THOMSON THT82 - Channel Search Options; Time and Timer Settings

English
11
16:9 Pillarbox A 4:3 programme will be shown normally, but with black bars to the left and
right.
16:9 Pan&Scan A 4:3 programme will be shown as a centre blow up to ll the whole screen,
missing content to the left, right, top and bottom of the programme.
Resolution If the video quality does not appear correctly, change the setting. These
settings match the most common settings for HDMI.
576p: For digital SD TVs (some digital TVs do not support this mode).
720p: For digital HD TVs (on HDMI connection).
1080i: For digital HD TVs (on HDMI connection).
1080p (50 Hz): For digital HD TVs (on HDMI connection).
Auto: The best possible resolution available will be auto negotiated by between
TV and receiver (‘handshake') when using a modern digital HD TV when
connected with an HDMI cable.
TV Format Options are PAL and NTSC. For European broadcasts, the TV format is PAL
(Default).
7.5 Channel Search
Auto Search This menu allows you to search for channels from all available frequencies
for your selected region automatically. Be aware that all previous installed
channels and favourite list(s) will be deleted. The new-found channels will be
installed in the channel list and afterwards you can create a new favourite
list if you like. Press OK to start the scan.
Manual Search Select a particular channel to do a search on just one (known) frequency.
Press OK to start the scan. The signal quality bar might be useful to
check if the frequency is indeed in use.
Country Select the correct country where this receiver is used. If failing to do so, may
result in that channels appear randomly in the channel list, instead of a more
logical order.
Antenna Power Set to On if you use an active antenna. When set to On, 5 V will be present
at the RF in connector of the receiver. Select O for passive antennas.
Scan Mode Select between FTA (Free-To-Air), which will only install Free-to-Air channels
or All, which will install all found channels, even if they are scrambled. Then
select Auto Search or Manual Search and press OK to start scanning.
7.6 Time
Set up your time zone for clock/time in your menu and system.
Time Oset The GMT time can automatically be determined from the incoming TV
broadcast if set to Auto. The time zone is determined from the Country
setting in the Channel Search menu. If set to Manual, you can change the
Time zone yourself in the Time Zone option. Default is Auto.
Time Zone If the correct time cannot be obtained from the incoming TV broadcast,
change the Time Zone setting yourself.
Example: in case of Daylight Saving Time.
Auto Standby As a power saving feature, the unit will switch to Standby automatically, if no
command from the remote control is received for the set time. Options are
1 Hour, 2 Hour, 3 Hour, O. Default is 3 hours.
Power On/O You can set a time to automatically switch On and/or Off the unit every day.
The unit will start on the last watched channel.
Note: Set Auto Standby function to O.
Power On Set to Enable if you want to use the automatically switch On function.
Power On Time Enter the switch On time with the numeric buttons on the remote control.
Power O Set to Enable if you want to use the automatically switch Off function.
Power O Time Enter the switch Off time with the numeric buttons on the remote control.