TSC 80e TRANSFER SWITCH CONTROLLER
PM091 Rev 0 09/01/21 Thomson Technology
29
Note:
If an asterisk (
*
) symbol does not stay displayed when attempting to
make a program change, an incorrect level of password has been
entered which will prevent changing the value.
5. Press the DOWN or UP keys to change numeric values or selection of programming
functions available. Once the desired value is selected, press the ENTER key to
accept the change. The asterisk will disappear.
To exit the programming sub-menus, press the ESC key. To exit back to the normal display
mode, press the ESC key again.