EasyManuals Logo

THORLABS DCU22 Series User Manual

THORLABS DCU22 Series
530 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #512 background imageLoading...
Page #512 background image
© 2013 Thorlabs GmbH510
DCx Cameras
Cameras & functions
Described in chapter
XP (32 bit).
The is_WriteI2C() function has been extended with the
IS_I2C_DONT_WAIT parameter. The default polling may be
disabled, whether the byte has been written into the storage cell.
The AVI functions of the uc480_tools.dll now supports
UNICODE strings for file names.
isavi_GetAVIFileNameW()
isavi_OpenAVIW()
The sample programs contain two new samples for .NET
programming.
See separate uc480 Samples Manual
The is_IO() function has been extended so that small flash
duration and flash delay can be set for flash via the GPIOs.
is_IO()
New in Version 4.01
Cameras & functions
Described in chapter
Support of the DCC1240x/DCC3240x with NIR sensor
DCC1240x/DCC3240x Camera and sensor
data
New camera family GigE uEye LE as board-level camera.
DCx camera family
Additional shutter modes and Log mode for DCC1240x/DCC3240x
cameras
uc480 Viewer > Properties > Shutter
The is_DeviceFeature() function was enhanced to control and
set the shutter modes and the Log mode of the DCC1240x/
DCC3240x.
is_DeviceFeature()
New function is_Blacklevel() for controlling the black level
is_Blacklevel()
The is_IO() function was enhanced to control the configuration of
the GPIOs.
is_IO()
Information in this manual
Decsribed in chapter
With the is_Blacklevel() function the following uc480 function
is now obsolete:
is_SetBlCompensation()
Obsolete functions
New in Version 4.00
Cameras & functions
Described in chapter
New camera family: DCC3240x
DCx camera family
Model comparison
Mechanical Specifications DCC3240x
Camera Interface DCC3240x
Added USB 3 specifications to the chapter about the USB interface
USB interface
New function is_AutoParameter() enables/disables the auto
white balance. This function is similar to the
is_SetAutoParameter() function but does not replace the
function completely in version 4.20.
is_AutoParameter()
The is_HotPixel() function supports now Unicode file names for
saving and loading of hotpixel lists.
is_HotPixel()
New function for the conversion of a raw Bayer image into a the
desired output format.
is_Convert()
New function for activating/deactivating the software edge filter.
is_EdgeEnhancement()
New function for saving the camera parameter set in a file or the
camera EEPROM and loading from a file or the camera EEPROM
respectively.
is_ParameterSet()
New function for controlling the camera pixel clock.
is_PixelClock()
New function for reading camera information.
is_DeviceInfo()
365
372
280
461
14
115
192
170
280
379
14
459
474
491
51
167
260
188
206
292
294
196

Table of Contents

Other manuals for THORLABS DCU22 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS DCU22 Series and is the answer not in the manual?

THORLABS DCU22 Series Specifications

General IconGeneral
BrandTHORLABS
ModelDCU22 Series
CategorySecurity Camera
LanguageEnglish

Related product manuals