THORLABS ITC502 - Monitor Diode Current Control

3.6 ITC5xx specific commands
ITC500 / page 76
3.6.9 Monitor diode current (IMD)
Programming:
Syntax: ":IMD:SET <NR3>"
Valid Range: Depends on the instrument type.
Default Value: 0 A
Assumption: The operation mode is set to constant power.
Description: Sets the photo diode current. Unit: [A].
Reading the set current:
Syntax: ":IMD:SET?"
Response: [:IMD:SET <NR3>]
Description: Queries the programmed photo diode current. Unit: [A].
Reading the minimum current:
Syntax: ":IMD:MIN?"
Response: [:IMD:MIN <NR3>]
Description: Queries the minimum allowed photo diode current. Unit: [A].
Reading the maximum current:
Syntax: ":IMD:MAX?"
Response: [:IMD:MAX <NR3>]
Description: Queries the maximum allowed photo diode current. Unit: [A].
Reading the actual current:
Syntax: ":IMD:ACT?"
Response: [:IMD:ACT <NR3>]
Description: Queries the actual photo diode current. Unit: [A].