Page 26 TTN200645-D02
PCS-6000 Series Motorized Patch-Clamp Micromanipulator Chapter 7: Maintenance
Figure 7–9 Carrycot Alignment of Pin in Slot (only bottom of pin is
visible)
Figure 7–10
15. If the alignment is correct, finish tightening the 4-40 screws that hold the
motor module to the stage.
7.1.3. Electronic Maintenance
There is no maintenance or serviceability items inside the control unit, ACU, or
joystick.
CAUTION
Hazardous Voltage. This unit is to be serviced by trained personnel only.
There are no operator-servicable components inside the PCS-6000 control
unit. Dangerous voltages are exposed when the cover is removed. Do not
attempt to open or service the unit yourself.
To Next Page
Loading...
