THUNDER TIGER raptor e700 - Main Gear Set; 主齒輪組組裝

-12-
No.
1
1-1
1-2
1-3
1-4
QtyDescription 名稱 No.
1-5
1-6
2
3
4
QtyDescription 名稱
MAIN GEAR SET
MAIN GEAR, 128T
TAIL DRIVE PULLEY, 111T
ONE WAY BEARING SHAFT
C-CLIP, #16
SOCKET SCREW, M2.5x6
ONE WAY CLUTCH HOUSING
SOCKET SCREW, M4x6
MAIN SHAFT LOCK RING
SOCKET SCREW, M3x6
主齒輪組
主齒輪(128T)
尾驅動輪(111T)
單向離合器軸
C型扣環, #16
內六角螺絲, M2.5x6
單向離合器座
內六角螺絲, M4x6
主軸止檔
內六角螺絲, M3x6
1
1
1
1
1
8
1
2
1
2
(4)
(4)
(3)
Secure all screws shown on this page with a drop of threadlocker.
本頁顯示之螺絲請使用適量防鬆膠鎖固。
Apply threadlocker
使用螺絲防鬆膠
Main Gear Set / 主齒輪組組裝
Bag E
SOCKET SCREW, M2.5x6
內六角螺絲 , M2.5x6
SOCKET SCREW, M3x6
內六角螺絲, M3x6
SOCKET SCREW, M4x6
內六角螺絲, M4x6
C-CLIP, #16
C型扣環, #16
(2)
(1)
(2)
(1-4)
(1-6)
(1-5)
(1-1)
(1-3)
(1-2)
Line up the holes of the Autorotation Tail Drive Gear, One Way Bearing Shaft
& Main Shaft, and then insert the Socket Screw to fix. Add a drop of
threadlocker when securing, but do not over tighten.
對正尾驅動齒、單向軸套及主軸上孔位後，鎖入內六角螺絲，並使用適量防鬆劑固定。
注意！請勿過度緊迫螺絲。
Lower the Upper Main Shaft
Bearing Block to eliminate the
play after securing all screws.
鎖固定位螺絲後，將上主軸軸承座
下壓以消除間隙。
Ensure smooth, non-binding movement when assembling
確認組件靈活度