THUNDER TIGER raptor e700 - Swashplate & Servo Direction Setting; 十字盤及伺服機方向設定; Index of Linkage Length; 連桿長度索引

-24-
Ensure there is none of the control bind at full travel before going through following setting procedures. Next, refer the
illustrations below to check the direction of servo & swashplate with a given transmitter input. Adjust the servo reversing
function in your transmitter if incorrect.
繼續設定前，請確認伺服機及連桿作動順暢且可達最大作動量。接著，請參考以下圖示，確認伺服機動作及十字盤混控設定可正確對
應撥桿動作。若作動方向不正確，請調整您發射機上的伺服機逆轉功能。
Mold 1 Mold 2
Servo Horn movement
伺服機擺臂動作
Check Point
機構動作確認
Aileron
副翼
Elevator
升降舵
Right Side / 右側
Front View / 前視圖
Left View / 左視圖
Left Side / 左側
Left Side / 左側
Swashplate & Servo Direction Setting / 十字盤及伺服機方向設定
Index of Linkage Length / 連桿長度索引
Rudder
尾舵
Right Side / 右側
Pitch
螺距
Right Side / 右側
Left Side / 左側 Left Side / 左側
Front View / 前視圖
42.55mm / 1.67”
68.6mm / 2.70”
Fixed Length / 固定長度
70.95mm / 2.79”
Fixed Length / 固定長度
70.95mm / 2.79”
Fixed Length / 固定長度