TiLite Aero X - Page 27

2-2
2GX/AERO X Owner’s Manual
OM_2GX/AERO X_0413RevA
CHAPTER 2: SAFETY INSPECTION, MAINTENANCE & TROUBLESHOOTING
Inspection Item Initially Weekly 3 Months
Camber Tube/Axle Sleeves
• Make sure camber plug clamps are securely tightened
• Make sure camber plugs are secure in camber plug clamps and axle
sleeves are secure in camber plugs
√
√
√
√
Handrims
• Inspect for signs of rough edges or peeling
• Make sure handrims are securely attached to rim
√
√
√
√
Wheel Locks
• Make sure wheel locks embed proper distance into tire and prevents
chair from moving when engaged
• Make sure wheel locks do not interfere with tire when disengaged
• Make sure pivot points are free of wear and looseness
√
√
√
√
√
√
Seat Sling and Back Upholstery
• Inspect for rips or sagging
• Inspect fastening aps to ensure they are securely attached
• Inspect while seated to ensure sling supports your weight and does not
touch crosstubes
√
√
√
√
√
√
Casters/Forks
• Inspect wheels and tires for cracks and wear
• Inspect wheel/fork assembly for proper tension by spinning caster
(caster should come to a gradual stop); if caster wobbles, tighten the
axle
• Inspect wheel/fork assembly/stem bolt to ensure that stem bolt is secure
(wheel/fork assembly should not have excessive play relative to the
stem bolt but should rotate freely); if necessary, tighten the stem bolt
• Ensure that wheel bearings are clean and free from moisture
• If pneumatic, check for proper ination as per the sidewall
√
√
√
√
√
√
√
√
√
√
Armrests
• Inspect to ensure that all hardware is securely attached √
√
Footrests/Hangers
• Inspect to ensure that all hardware is securely attached √ √
Anti-tips
• Inspect anti-tip wheel for cracks and wear
• Inspect to ensure that anti-tip receiver is securely attached
√
√ √
√
Frame
• Inspect for cracks √ √