TiLite Aero X - Swing Away- Flip Back Armrest

5-3
OM_2GX/AERO X_0413RevA
2GX/AERO X Owner’s Manual
CHAPTER 5: ARMRESTS
Removable Desk Arm Removable Desk Arm
Figure 5-4
Desk Arm
Housing
Height
Adjustment
Lever
Height
Adjustment
Lever
ArmrestArmrest
Release
Lever
Release
Lever
Desk Arm
Housing
Figure 5-5
Mounting Desk Arm
Desk Arm
Housing
Release
Lever
Desk Arm
Mount
Swing Away - Flip Back Armrest
To ip back the armrest, raise the front of the armrest and rotate it straight back as far as possible. Reverse this procedure
to return the armrest to its original position. See Figures 5-6 and 5-7.
To swing away the armrest, lightly lift up on the armrest and rotate the armrest away from the chair. See Figures 5-6 and
5-7. To replace the armrest, swing it back towards the chair and gently push it back down into place.
Note: The Swing Away Armrests pivot on nylon sleeves located inside the armrest receiver. If the armrest does not rotate
properly, check the sleeves for wear.