TiLite Aero X - Adjusting; Removing; Reinstalling; FOLD-DOWN RIGID SIDE GUARDS (Aluminum and Carbon Fiber)

6-2
2GX/AERO X Owner’s Manual
OM_2GX/AERO X_0413RevA
CHAPTER 6: SIDE GUARDS
Adjusting
Tools Needed:
• 1/8” Allen Wrench
You can adjust the “snugness” of the t of the bracket in the side guard mount by loosening or tightening the two Allen
screws in the side guard mount. See Figure 6-3.
Either type of rigid side guard can be made “non-removable” by rmly tightening the two Allen screws in the side guard
mount while the side guard is installed.
Figure 6-3
Adjusting
Bracket
Allen
Screw
Clamp
Dowel Pin
Allen
Screws
Side Guard
Mount
Washer
Removing
Tools Needed:
• 3/16” Allen Wrench
To remove the entire side guard assembly, including the clamp:
1. Remove the side guard from the side guard mount.
2. Remove the Allen screw that secures the two halves of the clamp to the frame. See Figure 6-3.
Reinstalling
Tools Needed:
• 3/16” Allen Wrench
1. Align the two halves of the clamp around the seat tube of the chair frame. See Figure 6-3.
Note: The half of the clamp to which the side guard mount is attached has a dowel pin protruding from the clamp that
must be inserted in the clamp hole in the frame.
2. Insert the Allen screw through the washer and the two halves of the clamp and securely tighten.
3. Insert the bracket into the side guard mount and adjust the two Allen screws as described under “Adjusting” on page
6-2.
Fold-Down Rigid Side Guards (Aluminum and Carbon Fiber)
Using Fold-Down Side Guards
The fold-down side guards utilize an internal spring. To fold down, simply remove the seat cushion and push the top of the
side guard toward the seat sling. To unfold, simply pull the side guard up away from the seat sling. See Figure 6-4.