Time Scylon - Assembling the Bike; Mounting the Seat

Assembly instructions
5. Assembling the bike
Before assembling the bike, check the compatibility of the accessories and components with the TIME frame.
In order to adapt the TIME Scylon frame to the height and position of the user, the fork pivot and the seat height
must be adjusted.
Tools needed:
Specic tools provided Conventional tools not provided
Headset adjustment levers (60003067) Torque wrench with hexagon socket
3 mm, 4 mm, 5 mm, and 6 mm
Cruciform screwdriver PH0 and PH1
Flat screwdriver 0.5 x 3.0 mm
Riveting pliers
Sawing guide
Metal saw
5.1 Mounting the seat
Seat assembly on the seat post:
The seat post comes with 2 sets of external cups that
will allow you to use either a seat with metal rails or a
seat with carbon rails.
- The cups
1
with an elliptical semi-diameter are for
the carbon seat frame.
- The cups
2
with a circular semi-diameter are for
the metal seat frame.
Scylon 06.jpg
- Assemble the seat
3
with the chosen
cups. TIME recommends greasing the cones and
seat cradles with the included "FSA Installation
Compound" grease to ensure perfect tightening.
Given the wide disparity of geometry
between the seat models, you must use
the seat that will be mounted on the new
bike.
You must choose your seat before
adjusting the seat height.
Scylon 07-2.jpg
- Pre-tighten the seat
4
to position it horizontally.
(tightening torque 8 Nm max)
Scylon 08.jpg
FSA - COMPOUND INSTALLATION
NIM_Scylon-01
7
EN