Time Scylon - Standard Seat Post

Assembly instructions
5.2.2 Standard seat post
- Adjust the correct seat height
1
.
- Lightly tighten the screws
2
of the clamp.
- Finalise the seat adjustment on the seat post (trim
and recoil).
- Final tightening of the seat to a maximum torque of
8 Nm
3
.
- Perform the nal tightening of the seat post to a
maximum torque of 4 Nm taking care to increase
the torque alternately on each screw.
Scylon 16.jpg
- Axis of the screw at the max extension mark: 211
mm
4
.
Under no circumstances should the seat
post be extended beyond the maximum
extension limit.
Scylon 17.jpg
NIM_Scylon-01
11
EN