Time Scylon - Choice of Transmission Type; Mechanical Transmission Assembly; Front Derailleur

Assembly instructions
5.4 Choice of transmission type
TIME Scylon frames are compatible with mechanical transmissions or with SHIMANO Di2, CAMPAGNOLO EPS
and SRAM eTAP electrical transmissions.
By default, the frame is prepared for a mechanical mounting, but also with the wire grommets for the electric
versions.
5.4.1 Mechanical transmission assembly
The routing of the cables for the derailleurs is done internally, and to facilitate their assembly and the replacement,
cable guides are pre-installed at the factory.
Scylon 24.jpg
Principle view: (viewed as if they were transparent).
- Sheath abutments
1
diagonal tube.
- Left cable guide
2
(front derailleur).
- Right cable guide
3
(rear derailleur).
- Internal grommet
4
.
- Sheath stop
5
on the base.
Once the brake handles have been tted to the
handlebar and the derailleur sheaths have been
cut to length, proceed with the installation of the
derailleur cables.
Front derailleur:
- Slide the cable
6
into the cable guide on the left
2
and pull it out at the front of the bases.
- Power up, then put the cable to the side
7
.
Scylon 25.jpg
NIM_Scylon-01
15
EN