Time Scylon - Page 16

Assembly instructions
Scylon frame rear derailleur:
- Slide the cable
8
into the cable guide on the right
side
3
and pull it out it at the rear of the right base.
- Remove the sheath stopper
9
from the base.
Scylon 26.jpg
- Pull the cable tight
8
to cut the functional length of
the sheath guide
3
.
- Then reposition the sheath stopper
9
on the base
and then set the derailleur cable aside
10
.
It is important that the cable guide tube
3
is su󰀩ciently short, so as not to be
constrained once the derailleur has been
assembled and adjusted.
Scylon 27.jpg
- Then remove the cable guide
11
(nylon threads) of
the electronic versions and position the plugs
12
for
closing the orices.
Scylon 28.jpg
NIM_Scylon-01
16
EN