Tinius Olsen MP1200 Extrusion Plastometer Page 14-6
Operation Manual # 02002215
14.2.20Press Continue to advance to the next screen.
14.2.21If the machine is equipped with a WLD and if it is desired to use it, press the
ON button located next to Enable Auto Cut.
14.2.22Time Limit – Enter a value of 30 minutes or less for the time limit desired for
the test. Press Continue to advance to the next screen.
14.2.23The next screen that appears allows the operator to select the Standard
Identifiers used to identify the specimens. Use of the Standard Identifiers is
optional.
14.2.24If desired, press the box next to Sample ID. This will allow the operator to
enter the sample ID, in alphanumeric format, prior to the test. A check mark
will appear in the box to confirm the selection. This is used only for
identification purposes on a printed test report.
14.2.25If desired, press the box next to Run Number. This will allow the operator to
enter the run number, in alphanumeric format, prior to the test. A check mark
will appear in the box to confirm the selection. This is used only for
identification purposes on a printed test report.
14.2.26If desired, press the box next to Operator. This will allow the operator to enter
the name of the operator that is conducting the test, in alphanumeric format,
prior to the test. A check mark will appear in the box to confirm the selection.
14.2.27If desired, press the box next to Procedure. This will allow the operator to
enter the procedure, prior to the test (in this case, it would Procedure B or C).
A check mark will appear in the box to confirm the selection.
14.2.28If desired, press the box next to Test Method. This will allow the operator to
enter the test method, prior to the test. A check mark will appear in the box to
confirm the selection.
14.2.29Comments (Pre-Test) - If desired, press the box next to Comments (Pre-
Test). This will allow the operator to enter comments, prior to the test. A
check mark will appear in the box to confirm the selection.
To Next Page
Loading...
