Tinius Olsen MP1200 Extrusion Plastometer Page 14-7
Operation Manual # 02002215
14.2.30Comments (Post-Test) - If desired, press the box next to Comments (Post-
Test). This will allow the operator to enter comments, after the test. A check
mark will appear in the box to confirm the selection.
14.2.31Enable Custom Identifiers – If the factory programmed identifiers are not
sufficient, custom identifiers may be created and selected here. To create the
custom Identifiers, return to the Program mode, Select Edit Custom
Identifiers, then Add Identifier. When the blank box appears, tap on it which
will cause a keyboard to appear. Type in the desired identifier, then press the
Done key. Press Save. Resume programming.
14.2.32Press the CONTINUE button to go to the next screen.
14.2.33The next screen allows the operator to select the results that will be displayed
at the end of the test. Press on the box next to the desired result. A check
mark will appear in the box indicating the selection is confirmed. The operator
may also activate alarms in the same manner. Press Exit when finished.
14.2.34 The next screen will allow the operator to Save changes.
14.2.35Cancel - Press Cancel to return to the Program mode.
14.2.36Don’t Save – Press Don’t Save to return to the Select Program screen.
14.2.37Save As – Press Save As to save a new program. Use the keyboard that
appears to enter the desired program name.
14.2.38Save – Overwrites existing file
To Next Page
Loading...
