Titan Implement, LLC 25 1200-1600 Series Rotary Cutters
(423) 334-0012 August 2016
9. Tighten the bolt suffi ciently to eliminate side play,
but still allow the break link to function.
10. Remove the four 5/16-18 x 1/2” bolts from the
front of the gearbox.
Note: The following steps are for rotary cutters
equipped with shear bolt drivelines. For rotary
cutters equipped with slip clutch drivelines, go to
Step 14.
11. Remove the protective cover from the gearbox
input shaft. Be careful not to lose the snap ring
located inside the cover.
12. Position the driveline shield on the front of the
gearbox and re-install the bolts.
13. Separate the two halves of the driveline.
To Next Page
Loading...
