1200-1600 Series Rotary Cutters 28 Titan Implement, LLC
August 2016 (423) 334-0012
22. Install the retaining bolt and tighten the locknut.
23. Apply a bead of grease around the end of the inner
drive shaft.
24. Slide the front driveline half over the rear half.
Align the square rib on the mating halves to
engage.
25. Apply grease to the zerk on the U-joint cross.
26. Close the access covers on the gearbox shield.
27. Attach the chain on the outer shield to the rotary
cutter.
To Next Page
Loading...
