What causes unusual noise in my Titan Cutter?
Unusual noise in your Titan Cutter can be caused by loose blade bolts or worn bushings, so tighten the bolts and check the bushings for wear, replacing them as needed. Bent blade carrier or blades can also cause unusual noises, so replace the blade carrier. Additionally, a bent deck causing the blades to contact it can be the source, so straighten the deck.
Why is grass cut lower in the center than the edge with my Titan Cutter?
If the grass is cut lower in the center of the swath than at the edge with your Titan Cutter, it's likely because the height of the rotary cutter is lower at the rear or front. Adjust the rotary cutter height and attitude so that the rear and front are within 1/2" of the same height.
Why won't the driveline telescope on my Titan 1306?
If the driveline on your Titan Cutter won't telescope, it could be due to improper lubrication, so grease the driveline. A twisted driveline can also prevent telescoping, requiring you to replace it. Ensure the operator does not strike the ground with the blades. A bent driveline, often caused by being too long, should be replaced and shortened to the proper length. Damaged shields should also be replaced.
Why is the driveline twisted on my Titan Cutter?
The driveline on your Titan Cutter might be twisted because it was overtorqued; avoid allowing the blades to contact the ground. Also, failing to maintain the correct PTO speed can cause this, so maintain 540 RPM PTO speed.
Why is my Titan Cutter leaving uncut material?
If your Titan Cutter is leaving uncut material, it might be due to excessive ground speed, so reduce it. Also, ensure that the RPM is not too low; maintain 540 RPM PTO speed.
What to do if the Titan 1306 Cutter material discharges unevenly?
If your Titan Cutter discharges material unevenly, creating bunches along the swath, it could be due to several factors. If the material is too high or there's too much of it, reduce ground speed while maintaining 540 RPM at the tractor PTO, or make two passes over the material, raising the rotary cutter for the first pass and lowering it to the desired height for the second, cutting at 90° to the first pass. Also, ensure the rear of the rotary cutter is high enough to allow material discharge, but not so high as to cause other issues. Wet grass can also cause this issue, so allow the grass to dry before mowing and slow the tractor's ground speed while keeping the engine at full PTO RPM. Lastly, the rear of the rotary cutter might be too low, trapping material underneath; adjust the rotary...
Emphasizes safety awareness, training, and potential hazards.
Explains hazard symbols (DANGER, WARNING, CAUTION) and safety icons.
Step-by-step instructions for assembling the rotary cutter, including driveline attachment.
Guides on how to safely connect and disconnect the driveline to the tractor PTO.
Stresses the owner's duty to train users on safe operation and maintenance.
Details necessary tractor specs like ROPS, PTO, HP, and weight for safe operation.
Step-by-step instructions for safely connecting and disconnecting the rotary cutter.
How to adjust cutting height and deck pitch for optimal mowing and safety.
Essential pre-use and operational checks to ensure safety and proper function.
Critical safety practices for operation, covering hazards like crush, thrown objects, and fire.
Safety precautions and regulations for transporting the rotary cutter on public roads.
Safety guidelines, PPE, and general shop practices for maintenance tasks.
Lists common issues like uneven cuts, windrowing, and loose bolts with causes and fixes.
To Next Page
General
