4
2
3
1
RECHARGE FUSERECHARGE FUSE
RECHARGE FUSERECHARGE FUSE
RECHARGE FUSE
( (
( (
(
ALL MODELS WITHALL MODELS WITH
ALL MODELS WITHALL MODELS WITH
ALL MODELS WITH
E.S.) E.S.)
E.S.) E.S.)
E.S.)
The fuse (1) is located in the electric starter relay (2) under the right
side panel.
After having removed the right side panel and the protective cap, it is
possible to access the fuse.
The fuse has a capacity of 30 amperes.
This fuse protects the following:
- recharging system
- battery
A spare 10 ampere fuse is also found in the starter relay (3).
SERVICES FUSE (ALL MODELS WITH LIGHTS)SERVICES FUSE (ALL MODELS WITH LIGHTS)
SERVICES FUSE (ALL MODELS WITH LIGHTS)SERVICES FUSE (ALL MODELS WITH LIGHTS)
SERVICES FUSE (ALL MODELS WITH LIGHTS)
The fuse is found in the relevant rubber fuse-holder (4) situated below
the left side panel (in SMR and SMM models it is under the right side
panel).
After having removed the left side panel (right for SMR and SMM) and
opened the fuse-holder, it is possible to access the fuse.
The fuse has a capacity of 7.5 ampere.
This fuse protects the following:
- lighting system
- direction indicator
- acoustic warning device
A burned out fuse must be replaced exclusively with an equivalent one.
If the new fuse should also burn out once mounted, contact a
specialised TM workshop.
WARNING
NEVER MOUNT FUSES WITH GREATER POWER OR TRY TO “REPAIR” THE SAME
FUSE. UNAPPROPRIATE TREATMENTS COULD CAUSE FAULTS TO THE ENTIRE
ELECTRIC EQUIPMENT.
REPLACEMENT OFREPLACEMENT OF
REPLACEMENT OFREPLACEMENT OF
REPLACEMENT OF
HEADLIGHTHEADLIGHT
HEADLIGHTHEADLIGHT
HEADLIGHT
//
//
/
POSITION LIGHTPOSITION LIGHT
POSITION LIGHTPOSITION LIGHT
POSITION LIGHT
BB
BB
B
ULBULB
ULBULB
ULB
(WITH STANDARD HEADLIGHTD END/SMR/SMM)
Release both elastic stripes and move the light-holder mask forward.
HEADLIGHT TWO-LIGHT BULB
Disconnect the blue, black and white cables and remove the rubber
protection (7). Release the retainer and carefully extract the bulb-holder
(8). Replace the bulb (9). Remount the bulb holder, the rubber protection
and the cables, respecting the position indicated.
POSITION BULB
Extract the bulb-holder (10) from the parabola, replace the bulb.
Remount the bulb-holder
Reposition the light-holder mask and fix it using the elastic stripes.
FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE
FRAME AND ENGINE MAINTENANCE
To Next Page
Loading...
Need help?
General
