TMQ AP9 Autopilot (V6.0 - 965) Page 44 of 51 31/1/2017
Special Mode Display Selection
901 Start compass calibration (page 55)
902 Store compass calibration (page 55)
903 Return to factory default calibration (page 56)
904 Not used
905 Set rudder limit switches (page 54)
906 Set commercial watch alarm (page 16)
907 Not Used.
908 Option remote
r-1 = two standard
r-2 = active remote
r-3 = hand remote + ext auto or power steer + steering lever
r-4 = hand remote + ext auto or power steer select + encoder
r-5 = two remote power steer + steering lever/wheel at main
r-6 = similar to r-5
909 Not used
910 Not used
911 Remote calibration (page 39)
912 Serial data out (page 43)
r-1 = HDM
r-2 = HDT
r-3 = HDM + CS
r-4 = HDT + CS
r-5 = HDM + HDT
r-6 = HDM = HDT + CS
r-7 = HDG + CS + Magnetic Variation
r-8 = ------
r-9 = HDG with Deviation of 0
r-10 = Serial to 10V device data (DVC 300)
r-11 = APRSA (Rudder Angle Sensor) + APHDT
(Autopilot data) + CS
Note: If COG is used to generate heading (as heading reference), then
ECVTG will be the serial data out. This is not dependent on the serial
data output selection.
To Next Page
Loading...
