34
3. When a filter type other than the settings on the previous page is selected
4. When Gain is selected
- The Filter-type display button displays the filter type of the selected filter point. Clicking the
button enables you to make a selection from the dropdown menu.
- The frequency of the selected filter point is indicated as a numerical value on the Frequency
display button. Clicking the button enables you to directly input a numerical value. Using the spin
button on the right, you can move the numerical values up or down in increments of minimum unit.
- The Q and Q2 display buttons display the Q values of the selected filter point. Clicking the button
enables you to make a selection from the dropdown menu.
- The gain of the selected filter point is indicated as a numerical value on the gain display button.
Clicking the button enables you to directly input a numerical value. Using the spin button on the
right, you can move the numerical values up or down in increments of 0.5 dB.
- The Polarity-inversion button displays the polarity status of the selected filter point. Click this
button to invert the polarity.
- The Response Viewer display button allows you to switch the response-area display on/off.
- The scale-change button allows you to change the graph scale of the Filter control.
- When The Table View button is pushed, Filter Control is displayed by the table form.
- Clicking Driver Alignment of the display-switching tabs displays the setting window for time
correction with the Xover box.
Filter-type display button
Frequency display button
Gain display button
Polarity-inversion button
Spin button
Increments selection switch
Local-grouping button
Options button
Delay-time display button
Delay-distance display button
To Next Page
Loading...
