Toa MM-700F - [Rear]

11
6. PRIORITY INPUT SIGNAL INDICATOR [PRIORITY 1, PRIORITY 2] (Green, Green)
PRIORITY INPUT SIGNAL1 Indicator: When the priority input 1 signal (14) exceed -36dBV
(line)/-86dBV (mic) the indicator lights.
PRIORITY INPUT SIGNAL2 Indicator: When the priority input 2 signal (14) exceed -36dBV
(line)/-86dBV (mic), the indicator lights.
7. CH1 PRIORITY INDICATOR [PRIORITY1, PRIORITY2] (Green, Green)
PRIORITY 1 Indicator：When PRIORITY 1 is activated and assigned to CH1 output, the indicator lights.
PRIORITY 2 Indicator：When PRIORITY 2 is activated and assigned to CH1 output, the indicator rights.
Note: 1. When PRIORITY MIX 1+2 switch is turned on and activated, these two indicator light at the same time.
2. The functionality of CH2, CH3, CH4 is the same as CH1.
8. CH1 PRIORITY INDICATOR [REMOTE] (Yellow)
When remote control panel WP-700 is connected to CH1 of REMOTE TERMINALS, the indicator lights.
At this time, both output level and input source selection could be changed by connected WP-700.
Note: 1. When WP-700 is connected, CH1 OUTPUT LEVEL CONTROL (3) and CH1 INPUT SELECT SWITCH (5)
on the front panel are defeated and controlled by WP-700.
2. When WP-700 is disconnected, the output level goes back to the setting of CH1 OUTPUT LEVEL
CONTROL( 3)
3. The functionality of CH2, CH3, CH4 is the same as CH1.
9. CH1 INPUT SELECT SWITCH 1 - 4
Select from LINE 1-4 inputs as the input source for amplifier CH1 output. Select again on the previous
selected input turns off the selection of input source.
Note: The functionality of CH2, CH3, CH4 is the same as CH1.
10. CH1 INPUT SELECT INDICATOR [1, 2, 3, 4] (Green)
The led will light with respect to the input select by the INPUT SELECT SWITCH (5) other channel which
is not selected will turn off.
Note: The functionality of CH2, CH3, CH4 is the same as CH1.
(*) MA-725F only
[Rear]