28
Step 2: Press [Cont] on the front panel to open a menu that specifies whether the digital multimeter will beep to
indicate the continuity.
The continuity measurement method is as follows:
≤ 10 Ω Display the measured resistance and beeps (if the buzzer is enabled).
10 Ω ~1.2 kΩ Display measured resistance, no buzzer.
> 1.2 kΩ Dsplay OPEN (ON), no buzzer.
4.2.11 Temperature test
This section describes how to configure 2-wire and 4-wire temperature measurements from the front panel.
Step 1: Configure the test leads as follows:
To Next Page
Loading...