63
Example: FREQ BEF
8.2.7.6 [SENSe:]PERiod:SECondary
Description: Select the auxiliary measurement function for the period measurement.
Please use DATA2? to read auxiliary measurement results.
Syntax: [SENSe:] PERiod:SECondary {OFF|BEForemath|ACV|FREQuency}
[SENSe:] PERiod: SECondary?
Parameters: {OFF|BEForemath|ACV| FREQuency }
Example: PER BEF
8.2.8 [SENSe:]TEMPerture Subsystem
8.2.8.1 [SENSe:]TEMPerture:NPLC
Description: Sets the integration time in terms of the number of power line cycles (PLC) for temperature
measurement.
The integration time is the period during which the instrument's analog-to-digital (A/D) converter measures the
input signal samples. A longer integration time gives a higher measurement resolution, but the measurement speed
is slower.
Syntax: [SENSe:] TEMPerture:NPLC {<plc>|MIN|MAX}
[SENSe:] TEMPerture: NPLC? [{MIN|MAX|DEF}]
Parameters: <plc>:{0.02|0.2|1|10|100}
Example: TEMP: NPLC 10
8.2.8.2 [SENSe:]TEMPerture:TRANsducer:{FRTD|RTD}:RESistance
Description: Select the nominal resistance (R0) for 2-wire and 4-wire RTD measurements. R0 is an RTD nominal
resistance at 0 °C.
Syntax: [SENSe:]TEMPerature:TRANsducer:{FRTD|RTD}:RESistance {<reference>|MIN|MAX}
[SENSe:]TEMPerature:TRANsducer:{FRTD|RTD}:RESistance? [{MIN|MAX|DEF}]
Parameters: <reference>: set resistance value
Example: TEMP:TRAN:RTD:RES 10
8.2.8.3 [SENSe:]TEMPerture:TRANsducer:TYPE
Description: Select a probe type sensor for temperature measurement. Supported probes are 2-wire and 4-wire
RTD, 2-wire and 4-wire thermistors
Syntax: [SENSe:]TEMPerature:TRANsducer:TYPE {FRTD|RTD|FTHermistor|THERmistor}
[SENSe:]TEMPerature:TRANsducer:TYPE?
Parameters: {FRTD|RTD|FTHermistor|THERmistor}
Example: TEMP:TRAN:TYPE RTD
To Next Page
Loading...