Tonghui TH1953 - Calculate: Limit Subsystem; Calculate: Average Subsystem

72
CALCulate:SCALe[:STATe]?
Parameters: {ON|1|OFF|0}
Example: CALC: SCAL: STAT ON
8.2.15 CALCulate: LIMit subsystem
This subsystem takes limit tests for the measurement results.
8.2.15.1 CALCulate:LIMit:LOWer[:DATA]
Description: Set the lower limit of the limit test
Syntax: CALCulate:LIMit:LOWer[:DATA] <value>
CALCulate:LIMit:LOWer[:DATA]?
Parameters: <value> set lower limit
Example: CALC: LIM: LOW -50
8.2.15.2 CALCulate:LIMit:UPPer[:DATA]
Description: Set the upper limit of the limit test
Syntax: CALCulate:LIMit:UPPer[:DATA] <value>
CALCulate:LIMit:UPPer[:DATA]?
Parameters: <value> set upper limit
Example: CALC: LIM: UPP 50
8.2.15.3 CALCulate:LIMit[:STATe]
Description: Enable or disable the limit test
Syntax: CALCulate:LIMit [:STATe] {ON|1|OFF|0}
CALCulate: LIMit[:STATe]?
Parameters: {ON|1|OFF|0}
Example: CALC: LIM ON
8.2.15.4 CALCulate:LIMit:CLEar[:IMMediate]
Description: Clear limit test results
Syntax: CALCulate:LIMit:CLEar[:IMMediate]
Parameters: (none)
Example: CALC:LIM:CLE
8.2.16 CALCulate: AVERage Subsystem
This subsystem calculates measurement statistics.