Tonghui TH1953 - Setting through the Interface

42
Command
Description
Control instructions for the TH1963 multimeter
REM
REMOTE 8
Bring the instrument into remote control mode
IFC
ABORT 8
Reset the instrument interface to the idle state
LLO
LOCAL
LOCKOUT
Block local messages so that all keys on the panel are
inoperable
GTL
LOCAL 8
The instrument returns to local control and the buttons on
the panel are active.
DCL
CLEAR
Clear all instrument input and output buffers
SDC
CLEAR 8
Clear the input and output buffer of TH1963
GET
TRIGGER 8
Trigger the instrument once, the measurement result will
be sent to the output buffer after measurement.
SPE,SPD
SPOLL 8
Serial point command
For a detailed description of the General Bus Command (SCPI), see Chapter 7: SCPI Command Reference.
6.5.4 Setting through the interface
Press Menu → Utility →I/O Config → GPIB to Enter GPIB Settings Screen.