64
8.2.8.4 [SENSe:]TEMPerture:SECondary
Description: Select an auxiliary measurement function for the temperature measurement.
Please use DATA2? to read auxiliary measurement results.
Syntax: [SENSe:] TEMPerture: SECondary {OFF|BEForemath|RESistor}
[SENSe:] TEMPerture: SECondary?
Parameters: {OFF|BEForemath|RESistor}
Example: TEMP BEF
8.2.8.5 [SENSe:]TEMPerture:ZERO:AUTO
Description: Enable or disable the auto zero mode for temperature measurement.
ON: The DMM internally measures the offset after each measurement. This measurement is then subtracted from
the previous reading. This prevents the offset voltage on the DMM input circuit from affecting the measurement
accuracy.
OFF: The instrument uses the last measured zero return measurement and subtracts it from each measurement. It
reads a new zero reading whenever you change the function, range or integration time.
Syntax: [SENSe:] TEMPerture:ZERO:AUTO {ON|OFF}
[SENSe:] TEMPerture: ZERO: AUTO?
Parameters: {ON|1|OFF|0}
Example: TEMP:ZERO:AUTO ON
8.2.8.6 UNIT:TEMPerture
Description: Sets the unit used for temperature measurement (°C, °F or Kelvin)
Syntax: UNIT:TEMPerature {C|F|K}
UNIT: TEMPerature?
Parameters: {C|F|K}
Example: UNIT: TEMP F
8.2.9 [SENSe:]CAPacitance subsystem
8.2.9.1 [SENSe:]CAPacitance:RANGe
Description: Select a fixed range for capacitance measurement.
Syntax: [SENSe:] CAPacitance:RANGe {<range>|MIN|MAX}
[SENSe:] CAPacitance:RANGe? [{MIN|MAX|DEF}]
Parameters: <range>:{1n|10n|100n|1u||10u|100u|1m|10m}
Example: CAP: RANG 100n
To Next Page
Loading...