Tonghui TH1953 - System Subsystem - General Command

67
8.2.10.9 SYSTem:COMMunicate:LAN:PORT
Description: Set the port number of the network port TCP communication.
Syntax: SYSTem:COMMunicate:LAN:PORT {<port>}
SYSTem:COMMunicate:LAN:PORT?
Parameters: port number
Example: SYST:COMM:LAN:PORT 45454
8.2.10.10 SYSTem:COMMunicate:LAN:SMASk
Description: Set the subnet mask.
Syntax: SYSTem:COMMunicate:LAN:SMASk {<smask>}
SYSTem:COMMunicate:LAN:SMASk?
Parameters: Subnet mask
Example: SYST:COMM:LAN:SMAS 255.255.255.0
8.2.11 SYSTem Subsystem - General Command
8.2.11.1 SYSTem:BEEPer[:IMMediate]
Description: Issue a single beep
Syntax: SYSTem:BEEPer[:IMMediate]
Parameters: (none)
Example: SYST:BEEP
8.2.11.2 SYSTem:BEEPer:STATe
Description: Disable or enable the buzzer sounding during continuity, diode or probe hold measurements, or
when an error occurs on the current panel or remote interface.
Syntax: SYSTem:BEEPer:STATe {ON|1|OFF|0}
SYSTem:BEEPer:STATe?
Parameters: {ON|1|OFF|0}
Example: SYST:BEEP:STAT OFF
8.2.11.3 SYSTem:CLICk:STATe
Description: When the front panel button or softkey is pressed, the button beep can be disabled or enabled.
Syntax: SYSTem:CLICk:STAT {ON|1|OFF|0}
SYSTem:CLICk:STAT?
Parameters: {ON|1|OFF|0}
Example: SYST:CLIC:STAT OFF