46
NOTE: Exiting mode decides whether to implement
SEt. At “Exiting without saving”, SEt is ineffective;
while at “Saving and Exiting”, SEt setting will be
effective.
Default Setting: PrE
Configure and Save Power-up State
Procedure to configure and save power-up state is as
follows:
1. Before entering into the utility menu, configure
all the measurement parameters firstly, such
as frequency, primary and secondary
parameters. If the meter is currently in the
utility menu, exit first and enter into utility
menu after measuring setup.
2. Press UTIL button for a long time to enter into
utility menu.
3. Push the UTIL button to traverse through the
utility options until you see “PuP” on the
primary display.
4. In order to save the current meter settings for
power-up state into internal memory, use
To Next Page
Loading...
