ToolKitRC M8 - Voltage and NiMH Settings; Cutoff Voltage Setting (TVC); NiMH Setting (PeakV)

@
ToolkitRC
2019
11
2，Cutoff voltage setting（TVC）
Move the cursor to [4.200V] and press [OK] to
modify the single-chip battery charge cut-off
voltage. Turn [Cod
e Plate] to adjust the value and step 1mV.
=================================
1, only LiPo, LiHV, LiFe battery can set the
cutoff voltage
2. Do not modify the cutoff voltage when you
are unfamiliar with battery characteristics.
3, the cutoff voltage can be set to the range
of positive and negative 50mV of full
voltage
4, vocabulary explanation: TVC: terminal
voltage control
=================================
3，NiMH Setting（PeakV）
When the battery type is NiMh, you can set the