19
PREPARATION BEFORE USE
4 Set "PC-50S" for "Device" of "For far vision" and "F" for "Type" (This manual will explain the
example in which "F" is used as "Type".). Then, select "PC-50S" for "Chart monitor selection".
5 Touch the [Chart software config.] button and then the [Chart settings] button. The "CHART
SETTINGS" screen appears. Set [Examination distance] according to the real test distance.
Touch the [OK] button and then the [Exit] button. The "Chart settings" screen appears again.
Refer to "SETTING THE CHART" on P.35 for the details about setting of chart.
6 Touch the [OK] button and then the [Exit] button to save the setting and finish the procedure.
To Next Page
Loading...
