Topcon Synergy GM-50 series - Setting Illumination of Display and Cross Hairs

6-17
6 SPECIAL MODE (Menu Mode)
6.3 Setting Illumination of Display and Cross Hairs
Setting ON/OFF/LEVEL (1 to 5) for illumination of display (LCD) and reticle.
Setting LEVEL (1 to 5) is only for reticle.
[Example setting] LEVEL:2 and turn on the illumination.
3 Press the {F3} (YES) key.
4 Enter Elevation. *1) Press the {F4} (ENT) key.
{F3}
Enter ELEV.
{F4}
5 Enter Scale Factor in the same way.
Enter Scale
{F4}
Grid Factor is displayed for 1 to 2 second and
display returns to menu.
*1)
Refer to Section 2.4 “How to Enter Alphanumeric Characters”.
 Input Range:Elevation : –9,999 to 9,999 meter (–32,805 to 3,2805 ft, ft+in)
Scale Factor: 0.990000 to 1.010000
Operating procedure Operation Display
1 After pressing the {MENU} key, press the {F4}
(P
↓ ) key twice to get the menu on page 3.
{MENU}
{F4}
{F4}
2 Press the {F1} key.
The data previously set is shown.
{F1}
3 Press the {F3} (LEVEL) key.
4 Press the {F2} (
↑
) key, and then press the {F4}
(ENTER) key.
{F3}
{F2}
{F4}
5 Press the {F1} (ON) key.
{F1}
 To return to previous mode, press the {ESC} key.
GRID FACTOR
ELEV.=1000 m
SCALE:0.999000
--- --- [CLR] [ENT]
GRID FACTOR
ELEV.:2000 m
SCALE=1.001000
--- --- [CLR] [ENT]
GRID FACTOR
=1.000686
MENU 3/4
F1:ILLUMINATION
F2:PARAMETERS 1
F3:PARAMETERS 2 P
↓
ILLUMINATION [OFF:1]
F1:ON
F2:OFF
F3:LEVEL
ILLUMINATION [OFF:1]
[LEVEL MODE]
↓ ↑ ––– ENTER
ILLUMINATION [OFF:2]
F1:ON
F2:OFF
F3:LEVEL
ILLUMINATION [ON:2]
F1:ON
F2:OFF
F3:LEVEL