5-2
www.topconpa.com
System 150 Auto Steer Setup Guide
AGI-3 Receiver LED Indicators Information
This section explains the meaning of the LED colors and patterns
displayed on the AGI-3 receiver when it is operating.
MINTER:
The MINTER is the receiver’s minimum interface used to •
display and control data input and output.
The PWR LED displays the power status for the receiver:
Steady Green – the receiver is turned on.•
No light – the receiver is turned off.•
The STAT LED displays the status of tracked satellites:
Red blink – receiver is on, but no satellites being tracked.•
Green blink – receiver is on and tracking satellites; one blink •
per tracked GPS satellite.
Orange blink – receiver is on and tracking satellites; one blink •
pertracked GLONASS satellite.
The RX/TX LED displays the status of the modem.
FH915 Plus and Digital UHF Modems:
No light – modem is turned off.•
Green ashes – modem is in receiver mode.•
Solid Green – a radio link has been established; modem isready •
to receiver data.
Solid Green plus Red ashes – modem is receiving data.•
Solid Red – modem is in transmitter mode.•
Red ashes – a fault condition has been detected. Check •
the condition of the radio modem’s antenna to ensure it is
undamaged, and is connected properly and securely. Also make
sure nothing interrupts the signal.
To Next Page
Loading...
Need help?
General
