6
6.3 Transferring receiver data 41
1. Plug one end of an RS-232 cable (9 pin
D-sub cable) into the RS-232 port on the
digital receiver, and the other end into
the matching port on the other digital re-
ceiver.
2. Turn on the source digital receiver.
3. Select the Installation > Transfer
Firmware > Transfer Data to Other IRD
menu, then you get asked for confirma-
tion; select Yes.
4. To start the data transfer, turn on the target digital re-
ceiver.
5. A progress bar appears showing the progress of the data
transfer.
6. Restart the target digital receiver when the data transfer
is complete.
To Next Page
Loading...
