16 Operation
4. Set the Motorized DiSEqC 1.2 and the USALS items ac-
cording to your antenna, LNB and satellite settings. If
the right Satellite Name and LNB Frequency were not
found in the list, call the dealer for satellite information.
5. Then, press
¤
£
¡
¢
OK button at Service Search item and go to
the Service Search menu.
6. Set the Search Mode to the Auto. (Manual, Advanced or
SMATV Search)
7. Select the Start Search. . . item and press
¤
£
¡
¢
OK button.
8. The search procedure will take a while. Press
¤
£
¡
¢
OK button
when the searching process is finished to confirm and
save the new service list.
9. For further information, please refer to Section 4.5.1 on
page 27.
Now this chapter assumes that the STB system has been in-
stalled correctly, meaning:
• The satellite dish for the STB has been installed, con-
nected to the STB and correctly adjusted to the proper
satellite.
• The STB is connected to the TV.
• The RCU has batteries and ready to control the STB.
If the STB has not been installed or connected properly, please
refer Chapter 3 Installation. Many of the functions of the STB
are available from the Main menu. Press
¤
£
¡
¢
MENU button to open
it.
To Next Page
Loading...
Need help?
General