34 Operation
Motor Control
Goto: Move the motor to the stored position of the selected
satellite.
Store: Store the current position of the motor for the selected
satellite.
The followings are available only at the Installer mode.
Recalculate: Recalculate the position of the Stab Rotor motor.
Goto Ref: Go to reference.
Limit E, Limit W: Set the limits of East and West position.
Limit Off: Remove the limitation.
Reset: Reset all the stored position of the motor relative to the
‘0’ position
Service Search
After saving the DiSEqC configuration at the highest signal
quality, press
¤
£
¡
¢
OK button to start service searching of the se-
lected satellite.
4.5.4 USALS Setting
USALS is very convenient motorized DiSEqC system that sup-
ports DiSEqC 1.3 command and also can get the satellite po-
sition automatically if you know your geographical location.
Basically, the listed satellites have its Longitude and therefore
the angle of the satellite can be calculated without problem.
If you have USALS motorized system, then you can use the
USALS as followings.
To Next Page
Loading...
Need help?
General