Need help?Do you have a question about the tornos DECO 13a and is the answer not in the manual?
Explains Machine Zero, Part Zero, and Tool Zero reference points for machine operation.
Details the minimum, maximum, and travel ranges for each machine axis.
Describes the function of each key on the NC keyboard.
Identifies and explains the function of each button and indicator on the control panel.
Lists and describes essential G-codes for motion and logic control in programming.
Lists and describes miscellaneous M-codes used for various machine operations.
Details the steps for referencing all axes or individual axes for machine homing.
Explains how to enter commands manually via the NC keyboard for direct machine control.
Describes how to move axes manually using jog or increment modes for precise positioning.
Explains how to select and run programs in automatic mode for production cycles.
Describes the process for accessing and modifying tool wear offsets for accurate machining.
Instructions for disabling axes X3, Z3, S3, X4, Y4, Z4 for specific operations.
Steps to download programs from a PC to the machine using an RS-232 serial cable.
Instructions for transferring programs to the machine using a memory card.
Details how to retrieve previously saved tool and program offsets.
Illustrates the belt and pulley arrangement for the S2 drive system.
Illustrates the belt and pulley arrangement for the S5 drive system.
Illustrates the belt and pulley arrangement for the S6 drive system.
Illustrates the belt and pulley arrangement for the S3 drive system.
Covers fundamental mouse and keyboard interactions within the Windows interface.
Describes procedures for copying files on the same or different storage disks.
Outlines the essential sequence of actions for setting up a new program in TB-DECO.
Provides visual instructions for refilling the chucking hydraulics system.
Details the process for updating tool support positions within the machine's database.
To Next Page
General
