QUICK REFERENCE − DECO 13A
en 300417 − 04/08 13
1.7 FUNCTION GROUPS
Each G−function belongs to a group 1 to 10. Group No. specifies proces-
sing order for these functions in a block.
Functions are processed in the following order:
Group 1 : System Commands
Group 2 : Modal G−Functions
Group 3 : Spindle Rotation Commands
Group 4 : Polygoning Spindle Commands
Group 5 : Spindle Commands for Phase Adjustment
Group 6 : Spindle Positioning Commands
Group 7 : Spindle ON/OFF Commands
Group 8 : Header/Footer Threading Commands
Group 9 : Threading Commands
Group 10 : Axis Commands
Group 11 : Basic M Commands
Group 12 : Additional M Commands
Group 13 : Machine Cycles
Note:
Tool call to be programmed either in a separate
line or together with Group 10.
To Next Page
Loading...
